My new train room I’m getting serious with. Helps me deal with my bad YouTube habit.
Starting Train Room
Author: james
2020 First CAD
1943 South Bend Lathe
My new Craig’s List Lathe
Arburg C4 Pi Image
Below is a link to the Arburg C4 Raspberry Pi image. The image can be burned onto a 32Gig SD card. Then, insert the SD Card into a Raspberry Pi Model 3.
Automotive Ultrasonic Hacking HowTo
Understand the Existing System
The first step in the process is to understand the existing system on a vehicle that is equipped with “Park Assists”. Just for background information, the term “Park Assist” was chosen for a reason. GM will tell you very quickly, this is NOT a safety device. This is for parking ONLY. Their fear is some bonehead will back over someone and claim the backup sensors never warned them. Not being considered a safety device made our lives much easier. That was good news since we had such a terrible time anyway. I could write a book about EMC testing!
Continue reading “Automotive Ultrasonic Hacking HowTo”Hacking GM Ultrasonic Park Assist Sensors
Abstract: A few years ago I worked on an ultrasonic park assist system for General Motors. We were awarded a small piece of business in early 2006. Our first modules and sensors made it into production in early 2008. Those two years were pure hell. I learned a lot about ultrasonic backup systems in those two years. My contribution was to develop all the embedded software for the control module. Our little company was eventually acquired by one of the big suppliers in mid 2008 (more stress – launching product while being taken over by a big fish at the same time.) By the end of 2008 I was totally burned out and left the automotive business. I’ve since moved on to start Powerhouse Electronics.
Continue reading “Hacking GM Ultrasonic Park Assist Sensors”Paint Pen Automatic Marker
Inspired by a MIG welder YouTube video, I built the following stepper motor controlled paint pen marker. Could also be used a Sharpy marker instead.
Here is the board design at OSH Park:
https://oshpark.com/shared_projects/MFHba3kD
Raspberry Pi Controls Temperature Chamber
Center Drill Depth Calculation
Old HAAS VF-3 Serial Port Repair
This page is my attempt to document my findings in regard to troubleshooting the serial communications problems we’re having with the HAAS VF-3 milling machine at i3Detroit. This work was done on Friday, September 13th.
